Oct 15, 2023 · I'm pretty sure it used to flow a lot quicker. It's difficult to even push filament through it manually. I don't think my nozzle is staying hot ...

Aug 8, 2022 · My theory is that at slow print speeds the filament spends more time in the nozzle and starts to overheat before leaving the nozzle, that's why ...

Oct 2, 2023 · I've tried clearing the nozzle with a nozzle needle and with a cold pull. Each time it will start out fine but then it eventually starts to fail ...

Apr 29, 2020 · Filament moves slower out of the nozzle than it is pushed into the tube. See above. According to devices here, I have made atomic pull about ...

Jul 28, 2014 · When it gets to printing, Im having first layer adhesion problems because of the extruder. The temps are ok, the bed is sticky and clean, ...

Jul 13, 2022 · I am trying to extrude polystyrene using a Filastruder that was set up by someone else at least a year ago. The polystyrene that I'm loading ...

Duration: 8:40
Posted: Mar 29, 2021